Digimerge DH100 Series Bedienerhandbuch PDF herunterladen (Seite 42)

30

Using the Main Menu

Sensor Setup

The Sensor Setup window allows you to

configure the sensor type, and the alarm

duration.

To configure Sensor Setup settings:

1. From the EVENT SETUP window, click

Sensor Setup.

2. Configure the following:

• Alarm Dur

ation (Seconds): Enter the

duration the system alarm continues to

activate after an event.

• Sensor Popup: When a sensor triggers, the

corresponding channel will open in full-

screen mode.

• Polarity: Select N.O (normally open) or N.C

(normally closed).

• All Off: Turns all alarm sensors off.

• All N.O: Selects all sensors as N.O

(normally opened).

• All N.C: Selects all sensors as N.C

(normally closed).

3. Right-click and click Ye

s to save your

settings.

SCHEDULE SETUP

Configure recording schedule, and

recording types.

To configure the Schedule Setup settings:

1. Click on the schedule on the left that you

wish to c

onfigure.

NOTE: You can configure up to 50 schedule

types.

2. Configure the following:

• E

nable Schedule Record: Select the

checkbox to enable scheduled recording.

• Enable Schedule Motion Detect: Select the

checkbox to enable motion recording.

• Enable Schedule Sensor Trigger: Select

the checkbox to enable alarm sensor

recording.

• Start Time: Enter the start time of the

scheduled recording.

• End Time: Enter the stop time of the

scheduled recording.

NOTE: Start Time must come before the End

Time. To create a schedule where the End

Select schedule

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare